PDA

View Full Version : Rm 505v advice please



solarradio351
01-25-2014, 01:16 AM
Hi there... Iv been looking at buying the rm505v, can anyone tell me if this is a good amp ? What are its downfalls if any
And what should I be looking for in a amp.. ? Any better quality avail to AUSTRALIA for $310 ?
Thanks for any advise or opinions.. Solar radio 351... Darryl :blah:

Tallman
01-25-2014, 10:09 AM
I repair amps and the RM line of amps are very sensitive to being over driven and voltage transients.. If you take care not to over drive it and watch for high peaks in your modulation and you should be good to go. Follow the directions and set it up as directed. Be sure your power lines are up to to the task. Go heavier in gauge than necessary and it should work out just fine.

solarradio351
01-25-2014, 03:41 PM
Thanks for that. I am aware not to to feed more power to amp than recommend..is that the big one to watch ?. But I'm not sure what
Transient voltage is or how to monitor / measure it ? Cheers ... Solar radio 351.. Darryl

Tallman
01-27-2014, 02:36 PM
When the voltage sags because the power cables aren't up to the task the bias for the transistors gets skewed a bit. I'll check into which type of transistors it runs and I'll get back to you.

solarradio351
01-29-2014, 07:55 PM
Very handy info guys.. I can get a MF amp are they a better quality than RM ?
Cheers, Darryl...