preps
Page 1 of 2 12 LastLast
Results 1 to 10 of 17

Thread: A/C Power supply

  1. #1
    Join Date
    May 2013
    Location
    Blue Ridge Mountains, Tn
    Posts
    211
    Thanks
    12
    Thanked 82 Times in 62 Posts
    Downloads
    0
    Uploads
    0

    A/C Power supply

    What size power supply would I need for my Stryker 955? I'm thinking of moving it inside for awhile. I also will need suggestions for a base antenna. Thanks in advance for any help.
    73




    73 The Fogdog is clear and out of here!

  2. #2
    Join Date
    Sep 2015
    Location
    Daytona Bch, FL
    Posts
    202
    Thanks
    49
    Thanked 72 Times in 55 Posts
    Downloads
    0
    Uploads
    0
    A 15-20 amp power supply should be ample for the radio. Megawatt makes a pretty good switching power supply, the S400-12, it's 36amps. They cost about $60. Go to megawatt.com and check them out. Built in the US, and have 2yr warranty. Also they don't have any hash as far as I have noticed anyway. I use one with an Icom 746 and it runs its fine @ 100w no problem. Again, no hash that I have found either.
    As for a base antenna, not sure what you are trying to accomplish. You want a vertical or a beam antenna. For vertical the Sirio Vector 4000 is a great antenna as long as you don't live in a high wind area. If this is the case there are other antennas as well, the Sirio 2016, 827, the Gain Master, and also other antennas. The shockwave antenna made in the US, is a sweet antenna, but it's expensive. Same with the I10k or Mr. Coily antennas as well. The ones I listed are all 5/8 wave antennas or close to 5/8 wave minus the vector 4000 which is a 7/8 wave antenna.
    There are many more antennas I could name that would work as well, but I am a big fan of fiberglass. Some like the the IMAX 2000. Not a bad antenna. Like I said. I just like aluminum better.
    I am currently using a Sirio vector 4000 that is up 26ft to the base of the antenna. Tip height is around 54ft with the antenna being around 28ft long. I can talk consistently out to about 70 miles locally no issues, and when it's quiet as far as floor noise goes I can reach the west coast of FL, from Daytona to Tampa, which is about 130 miles or so. And that is with about 50w of power being used on SSB. Could probably use less and still make the trip, but it never hurts to have a little more than 12w at times.
    Now there are beam antennas as well that will work very well if setup right. A 3 element beam or even a quad type antenna with dual polarity, meaning it has both horz, and vert., capabilities work very well. Get most any decent antenna off the ground as high as possible and use good coax and connectors. Also a good ground system and a surge arrestor, a low pass filter, and a good ground system, as well as tuning the antenna properly all help your setup be as good as it can. I am sure I missed something, but there is enough here to at least get you started. As far as power supplies go, any good 20 amp supply should be about right for that radio. I would look into something a little bigger than 20A just to have good headroom and also the option to add other things to it. Again, I've had very good luck with the megawatt power supply i have. Had it for about 3yrs now and it still performs like when I purchased it. Set to 13.8v with 30+ amps of power I have never had an issue with it and like I said, I use an HF radio with it. Also great customer service. Not saying that a different supply won't work, just giving my experience with ones I have used. Stay away from the pyramid supplies! Astron, Meanwell, megawatt, and some others all will work as long as you get one with proper amperage. I would look for something that will give you about 1.5 times the amps needed. So if your radio draws 15A, a 20-25 amp supply min. Is what I would look for. And also stay away from the cheap power supplies as well as they don't have good filtering and may cause some unwanted noise. These are JMHO. Hope all this helps. Good luck with whatever you decide. Have a good one.

  3. The Following User Says Thank You to 222FL For This Useful Post:

    BOOTY MONSTER (05-12-2016)

  4. #3
    Join Date
    May 2013
    Location
    Blue Ridge Mountains, Tn
    Posts
    211
    Thanks
    12
    Thanked 82 Times in 62 Posts
    Downloads
    0
    Uploads
    0
    222FL, thanks for that write up. That power supply sounds like the one I need. As for the antenna, I'm live in the mountains. I have one right behind me and pretty much all around me
    I'm at 3,000 ft elavation, and the mountains around me are around 4,000-5,000 ft. Im also in a heavily wooded area. The whole thing is going to be a challenge I guess. I'm not sure if one antenna is better than others for these conditions.
    Attached Images Attached Images  




    73 The Fogdog is clear and out of here!

  5. #4
    Join Date
    May 2013
    Location
    Blue Ridge Mountains, Tn
    Posts
    211
    Thanks
    12
    Thanked 82 Times in 62 Posts
    Downloads
    0
    Uploads
    0
    We also have lots of high winds here.




    73 The Fogdog is clear and out of here!

  6. #5
    Join Date
    Sep 2015
    Location
    Daytona Bch, FL
    Posts
    202
    Thanks
    49
    Thanked 72 Times in 55 Posts
    Downloads
    0
    Uploads
    0
    Looks beautiful that is for sure. At any rate, with all the trees, a vertical antenna or even a dipole hung between 2 trees would work. I suppose you don't have many locals. If this is the case, then setup 2 dipoles, horz. As high as you can, one pointed N/S and the other E/W, and use a switch to transfer between them. Either that or get a good vertical antenna and get it up as high off the physical ground as possible. Keep it away from the trees as much as possible. I know this won't be easy. But find a spot around the house that doesn't have trees real close. If possible place antenna here. Or you could mount one on the roof with a good tripod mount.
    Also if possible, getting into the top of one of the nearby trees and mounting an antenna on a pole as so the antenna itself is totally above the top of the tree. Looks as if that might be viable if the trees are sturdy enough to bare the weight of a person near the top. And as far as vertical antennas go, like I said, if the wind isn't bad where you are, then I would recommend the Sirio vector 4000. If you do have bad winds and such, try an IMAX 2k or a good commercial antenna like a 5/8 wave shockwave antenna. They cost a bunch but are built like a tank!!
    The Sirio 2016 and 827 are pretty heavy duty antennas as well. But not as nice as the others I mentioned in my other post like the Mr. Coily or I10k or even the Shockwave (US) made version. It all depends on how much you would like to spend and what areas you have to use the antenna. Dipoles with a good 1:1 balun are easy to string up between 2 trees and work great for dx. Get them above 30ft. and they work very well. You can place them either horz. or as an inverted V. I like horizontal myself, but they are a bit more directional and also not very useable for local use. But for dx they do work great!!! I actually took my 2 dipoles down as my vector 4K works just as good as my dipoles did or better. Don't have the rejection of the dipoles of signals that I don't want to hear, but it transmits and receives just as well as my dipoles did at 35-40ft off the ground. Anyways. Again, look around d and think about what you truly want to accomplish then go for it. The DX isn't real great right now. It's sporadic to say the least on 11m at least. But with the proper antenna setup you can talk pretty far locally. Again, just my experience with the few antennas I have used and also installed or read a lot about. Hope something might help. Be safe whatever you do. And just google megawatt power supplies. He has a website. 73 and God Bless.

  7. #6
    Join Date
    May 2013
    Location
    Blue Ridge Mountains, Tn
    Posts
    211
    Thanks
    12
    Thanked 82 Times in 62 Posts
    Downloads
    0
    Uploads
    0
    ^^^^, again thanks for all the in depth info. That clears it up for me a lot. I have the mobile installs down pretty good, but a base station is new to me. Looks like I have some work to do. I looked up megawatts Web page, and I will be buying one of these. Thanks again for your help. Oh , by the way. When I was out in California shooting skip out of my pickup, we actually talked once over the air. I haven't had much luck up here yet. My radio is in my UTV right now, and I just don't here that much except on the super bowl (ch 6).




    73 The Fogdog is clear and out of here!

  8. The Following User Says Thank You to Fogdog For This Useful Post:

    222FL (05-21-2016)

  9. #7
    Join Date
    May 2013
    Location
    Blue Ridge Mountains, Tn
    Posts
    211
    Thanks
    12
    Thanked 82 Times in 62 Posts
    Downloads
    0
    Uploads
    0
    Just out of curiosity, is there a way I can rig my Predator 10K dual coil antenna into a base antenna. I'm not currently using it, and was wondering.




    73 The Fogdog is clear and out of here!

  10. The Following User Says Thank You to Fogdog For This Useful Post:

    222FL (05-21-2016)

  11. #8
    Join Date
    Sep 2015
    Location
    Daytona Bch, FL
    Posts
    202
    Thanks
    49
    Thanked 72 Times in 55 Posts
    Downloads
    0
    Uploads
    0
    Not really, as you would need a large steel plate under the antenna and also be able to get it up in the air. This won't be easy and most height you'll most likely get is top of roof if that is even possible. Like I said, you need some metal under that antenna, your predator 10k.
    Build yourself a dipole! They are cheap and if you build it properly you can get them to match at 50ohms with a piece of 75ohm tv coax, 18ft of #14awg or even smaller, a couple of insulators, these can be bought at Home Depot for a couple dollars or if you have some old flex conduit connectors laying around you can use them as well. You'll also need an SO-239 connector.
    Or you can buy one off eBay for about $15 dollars shipped.
    Either way, string it up between a couple trees as high as you can. Shoot my first one was about 8ft off the ground and I worked Australia from FL with a barefoot Uniden PC122XL on SSB, 12 watts of power. Using a home made dipole with parts like the ones I listed above. 8.6ft per side is approx what is needed and also a piece of 75ohm coax to bring the impedance down to 50ohms. Read up on how to build one. They truly are an easy antenna to build and you can also make an end fed vertical one as well.
    Like I said, your predator 10k is going to be way hard to tune without some decent metal under it. Not like a base antenna.
    Do some searching on eBay and you can find dipoles for really cheap. They aren't that hard to build and really do work for dx. And if hung vertically and setup correctly, they can also be used as a vertical antenna for local and DX use. There is an app called antenna calculator on Apple anyways that will help you with length of the antenna as its all dependent on the freq. as to how you tune one. Meaning you cut the antenna to be resonant at what frequency you are wanting to use it on and near. Dipoles are not real broad banded but will let you get the CB band and some no problem. Also can be used on other bands for RX anyways.
    At any rate, sorry for rambling. Hope some of this helps and they are JMHO's as well as my own experience messing with the same antennas! Tried my single coil 10k and it wouldn't tune very well!! Even with a 3'x3'X1/4" steel plate under it! Again, hope some of this helps and good luck.

  12. #9
    Join Date
    May 2013
    Location
    Blue Ridge Mountains, Tn
    Posts
    211
    Thanks
    12
    Thanked 82 Times in 62 Posts
    Downloads
    0
    Uploads
    0
    Thanks again, lots of good info. I've thought of a dipole, still might go that. Searching for the best trees to run one up. The tree line is about 70 feet from my house, so if I can run coax that far without to much signal lose I'll be good. I might end up with an antenna farm for ,10,11, and 2 meter. Got my work cut out for myself.




    73 The Fogdog is clear and out of here!

  13. The Following User Says Thank You to Fogdog For This Useful Post:

    222FL (05-12-2016)

  14. #10
    Join Date
    May 2013
    Location
    Blue Ridge Mountains, Tn
    Posts
    211
    Thanks
    12
    Thanked 82 Times in 62 Posts
    Downloads
    0
    Uploads
    0
    Got my Megawatt power supply today (s-400-12x36), and it's working great. The parts needed for my base station ate tricking in.Name:  20160520_152338.jpg
Views: 235
Size:  1.54 MB




    73 The Fogdog is clear and out of here!

Visitors found this page by searching for

None

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •