preps
Page 2 of 2 FirstFirst 12
Results 11 to 16 of 16

Thread: Direct injection on a Cobra 142 GTL

  1. #11
    Join Date
    Sep 2016
    Location
    Central KY
    Posts
    161
    Thanks
    16
    Thanked 41 Times in 31 Posts
    Downloads
    16
    Uploads
    0
    i just put the cap back in and i still have audio out of the stock mic jack with a mic hooked up
    Happy DXing

  2. #12
    Join Date
    Nov 2011
    Location
    North NJ
    Posts
    563
    Thanks
    13
    Thanked 458 Times in 110 Posts
    Downloads
    166
    Uploads
    829

    My Social Networking

    Follow doughboy On Twitter Add doughboy on Facebook
    Visit doughboy's Youtube Channel
    Are you sending in a line level signal like a mixer or something if so replace c119 back in the mixers probably to weak to drive it and go into the negative side of c83 that will leave some preamp circuit inline

  3. #13
    Join Date
    Sep 2016
    Location
    Central KY
    Posts
    161
    Thanks
    16
    Thanked 41 Times in 31 Posts
    Downloads
    16
    Uploads
    0
    i was running an m-audio moblepre into it and it was dead as dead could be. it was amplified. ill try c38. is that close to the c119? remove its cap too? and negitive side, not positive?
    Happy DXing

  4. #14
    Join Date
    Nov 2011
    Location
    North NJ
    Posts
    563
    Thanks
    13
    Thanked 458 Times in 110 Posts
    Downloads
    166
    Uploads
    829

    My Social Networking

    Follow doughboy On Twitter Add doughboy on Facebook
    Visit doughboy's Youtube Channel
    Sorry I corrected my post c83 not c38 the reason c119 is not working it drives Darlington directly you would have to feed with like a 20 watt amplifier it's basically and external modulator setup at c83 you will use radios built in modulator but bypass most of the preamp

  5. #15
    Join Date
    Sep 2016
    Location
    Central KY
    Posts
    161
    Thanks
    16
    Thanked 41 Times in 31 Posts
    Downloads
    16
    Uploads
    0
    oh ok. so remove cap on c83 and wire the lead to the negative side and then ground the other wire?
    Happy DXing

  6. #16
    Join Date
    Sep 2016
    Location
    Central KY
    Posts
    161
    Thanks
    16
    Thanked 41 Times in 31 Posts
    Downloads
    16
    Uploads
    0
    Thanks doughboy! I ran my audio lead into the negative side of c83 and grounded the shield. My M-Audio MobilePre is running into it. Sounds really good. Thanks!


    Sent from my iPhone using Tapatalk
    Happy DXing

Visitors found this page by searching for

http:www.cbjunkies.comthreads1804-Direct-injection-on-a-Cobra-142-GTL

cobra 148 gtl direct injection

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •