preps
Results 1 to 3 of 3

Thread: Dx 1600x needle only goes to 3 when I talk on my Stryker 447hpc

  1. #1
    Join Date
    Feb 2017
    Location
    Ross Ohio
    Posts
    4
    Thanks
    0
    Thanked 1 Time in 1 Post
    Downloads
    0
    Uploads
    0

    Dx 1600x needle only goes to 3 when I talk on my Stryker 447hpc

    Used to run a TS 500 it didn't push it very hard either. I want to peg needle on linear. How do I get it done. Do have a alpach one pill on shelf. I'm driving a 03 w900L. Dead key 1.5 watt swing 30 to 50 watt. Could I use that alpach to drive dx 1600

  2. #2
    Join Date
    Dec 2011
    Location
    RICHMOND VA.
    Posts
    715
    Thanks
    402
    Thanked 251 Times in 167 Posts
    Downloads
    0
    Uploads
    0
    i wouldn't push the DX1600 past 1600 watts . the difference between 1600 watts and 3200 watts is trivial and contact success will only be noticed on rare occasions .... then there's bleed-over/splatter and over-modulation to deal with not to mention shortening the life of the amp . if you want more power get a bigger amp , and most likely alternators and batteries too .

  3. The Following User Says Thank You to BOOTY MONSTER For This Useful Post:

    222DBFL (02-24-2017)

  4. #3
    Join Date
    Sep 2012
    Location
    spotsy
    Posts
    92
    Thanks
    4
    Thanked 64 Times in 40 Posts
    Downloads
    0
    Uploads
    0
    it has spoken

Visitors found this page by searching for

None

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •